With graduations upon us now I wanted to share with you a super easy gift card holder that I made recently.
How about some measurements and quick instruction? Here you go then:
- cardstock (base): 7- 3/4″ x 5″ and score at 2-1/2″ and 6″
- cardstock (inside stamped piece): 2-1/4″ x 4-3/4″
- cardstock (belly band): 1″ x 7-3/4″
- DSP (top): 2- 1/4″ x 4-3/4″
- DSP (bottom): 1-1/2″ x 4-3/4″
Just adhere the sides of the small flap so it will hold the gift card. Wrap the belly band around the holder and adhere closed. I used various punches to hide the end pieces. It comes together in a matter of minutes. Enjoy!
All Supplies Stampin’ Up! | ||
Unless otherwise noted | ||
137159 | B.Y.O.P. Photopolymer Stamp Set | $24.95 |
135380 | Bravo Photopolymer Stamp Set | $25.95 |
133675 | Blackberry Bliss Cardstock | $6.95 |
121043 | Sahara Sand Cardstock | $6.95 |
100730 | Whisper White Cardstock | $8.50 |
133701 | Moonlight Designer Series Paper Stacks | $6.95 |
133642 | Blackberry Bliss Classic Stampin’ Pad | $5.95 |
126889 | Stampin’ Trimmer | $29.95 |
104332 | SNAIL Adhesive | $6.95 |
104430 | Stampin’ Dimensionals | $3.95 |
104294 | Sticky Strip | $6.95 |
102300 | Bone Folder | $6.95 |
126189 | Paper-Piercing Tool | $3.95 |
126199 | Stampin’ Pierce Mat | $4.95 |
118874 | 2-3/8″ Scallop Circle Punch | $16.95 |
119850 | 1-3/4″ Circle Punch | $16.95 |
133782 | 2″ Circle Punch | $16.95 |
124094 | 1″ Square Punch | $15.95 |
1 thought on “Congratulations, Grad!”